目前吸金樹脂市場,多采用進口樹脂,我司代理的Tulsion A-21S 與A-654 以選擇性強,交換容量大等受到廣大客戶好評,其不僅性能優越,而且價格低廉。
A-21S 吸附容量在100g/L 以上,處理后尾液中殘留金的含量小于0.02ppm。
A-654 可以在高鎳以及高銅等環境下,選擇性吸附金,其交換容量幾乎為A-21S 的兩倍,在起同類產品中,幾乎找不到類似產品。
吸金樹脂在PH 值為0-14 時均能進行交換反應,但再生洗脫相對較為困難,同時使用的再生劑消耗大。因此對于一般中小型的設備而言,可釆用火法焚燒回收黃金,當中樹脂的價值僅為黃金價值的0.5%左右。當吸金樹脂吸附的黃金達到飽和的時候,樹脂可以送交專門的回收單位進行黃金回收或自行回收提取。回收黃金的時候,由于在焚燒過程中有刺激性氣味和腐蝕性氣體產生,因此要設計好良好的通風設施防止氣體、臭味等污染環境。
吸金樹脂
(1)A-21s 產品知識:黃色(國產白色),凝膠型;只能處理氰化金,不能處理金離子; 應用行業:冶金(濕法冶金),電鍍鍍金,廢電子回收
優勢:1.交換容量大,一般1L樹脂吸附黃金100g,品位差(溶液含金少)的1L樹脂吸附黃金50g.
2.選擇性好:在金、銅、鎳等都含的時候,只選擇性吸金。
3.溶液殘留少,少于0.02ppm,相當于尾液不含金
(2)A-654MP 產品知識:大孔型;
優勢:選擇性更好,在高鎳高銅的情況下仍然只吸金;交換容量是A-21S的兩倍
T ulsion? A-21S
ISO-9001/ISO-14001/OHSAS-18000
"無裂紋"強堿型陰離子交換樹脂 I 型
T T T T ulsion ulsion ulsion ulsion? A-21 S 是一款聚苯乙烯架構的強堿型陰離子交換樹脂。它具有優越的化學性
能的特殊的銨官能基,并且由于其tr的無裂紋特性而具有優異的操作性能。
T T T T ulsion ulsion ulsion ulsion? A-21 S 當與強酸型陽離子交換樹脂一起用在水處理中時,對于弱酸,強無機
酸和鹵化物等具有{jj0}的操作性能。
T T T T ulsion ulsion ulsion ulsion? A-21 S 以一定的粒徑范圍生產供應,為氯型的濕潤球狀,具有良好的動力性
和最小的壓降。
典型特性(TYPICAL CHARACTERISTICS) : Tulsion? A-21 S
型式/Type 強堿性陰離子交換樹脂/Strongbase anionexchangeresin 主體結構/Matrixstructure 交聯聚苯乙烯/Cross-LinkedPolystyrene 物理型式/Physical form 濕潤球狀/MoistSphericalbeads 離子型式/Ionic form 氯/Chloride 總交換容量/Totalexchange capacity 1.3meq/ml 目數/Screen sizeUSS(wet) 16to50 粒徑/Particle size 0.3-1.2mm 濕度/Moisturecontent 54±3% PH 范圍/PHrange 0-14 反洗密度/Backwashsettleddensity 42-44lbs/ft3(670 -710g/L) 溶解性/Solubility 不溶/Insoluble inall common solvents
操作條件特性(TYPICAL OPERATING CONDITIONS): Tulsion? A-21 S {zd0}操作溫度/MaxOperatingtemperature 60℃ 樹脂床高度/Resin beddepth 800mm {zd0}流速/Maximumserviceflow 60m3/hr/m2 逆洗膨脹空間/Backwashexpansion space 60-75% 逆洗流速/Backwashflowrate 5-10m3/hr/m3 再生劑/Regenerant NaOH 再生程度/Regenerationlevel 40-160g/l 再生劑濃度/Regenerant concentration 4-5% 再生流速/Regenerationflow rate 5-10m3/hr/m3 再生時間/RegenerationContact time 30-60min 再生慢流速/Regeneration slowrinse 2BVminimum 慢沖洗流速/Slowrinseflow rate 再生流速/At regeneration flow rate 快/Fast 工作流速/At service flow rate 快沖洗量/FastRinseVolume 4-6BV
金 回 收 : : : : 用 使用 TULSION ? ? 離子交換樹脂從氰化物溶液中回收金. . . .
d Gold y Recovery : : : : From e cyanide r liquor USING TULSION ? ? ION EXCHANGE RESIN.
簡 介/ / / / INTRODUCTION : : : :
傳統上使用活性碳吸附金子。 珍貴的金會被活性碳吸附于表面,再藉由洗滌或直接焚燒以回收金。
Conventionally activated carbon is used for extracting the gold from the mother
liquor commonly contacted with beds of activated-carbon. The precious noble metal
loaded on the activated carbon is recovered by elution or simply by incineration of
the carrier at high temperature.
使用離子交換樹脂回收貴金屬比活性碳還具有多方面的優勢 , 因為藉由特殊制造過程中 , 我們
可以在其結構上的有效官能基上置入具有選擇性的離子 ,以選擇性的吸附此貴重金屬 。
Ion exchange resins are more versatile substrates than activated carbons can be
used, because specific functional groups can be afixed on the resin matrix, for
better selectivity, during the synthesis. These resin can be tailor-made to improve
the gold carrier features such as selectivity, resistance to poisoning by calcium or
organic materials and loading capacity.
因此 , 由于具有經濟考慮優勢 , 離子交換樹脂普遍被使用于貴金屬回收。而大部份使用陰離子交
換樹脂來交換吸附貴金屬。
Therefore the ion exchange resins are economically adopted for the gold recovery.
Mostly Anionic type of ion exchange resin are used that adsorb the gold
用氰化物萃取金的過程中 , 金會以陰離子的氰化金型式存在 , 既 Au(CN) 2 - ; 再經由強堿或弱
堿的陰離子交換樹脂交換回收。如 T T ulsion ? ? ? ? A-23(強堿), T T ulsion ? ? ? ? A-27mp(強堿)及
T T ulsion ? ? ? ? X A-2X p mp (弱堿) 。
The gold extracted by cyanidation is in the form of anionic aurocyanide complex
Au(CN) 2 - and can be recovered from the pregnant solution by ionic exchange with
strong or weak base anion exchange resin ,such as T T ulsion ? ? ? ? A-23, T T ulsion ? ? ? ? A-
P 27MP and T T ulsion ? ? ? ? A-2XMP
) (a) 用 強堿離子交換樹脂方面的應用 : : : :
此型的強堿型陰離子樹脂具有四級銨的官能基 ,在高 pH 值的溶液中 ,藉由交換氯離子的相反離子
來吸附 Au(CN) 2 - ; 其反應機構如下 :
) (a) STRONG E BASE ANION:
These resins contain quaternary ammonium functionality which, when contacted
with the high pH leachate stream, adsorb the aurocyanide anion via exchange for
the resin's chloride counter-ion:
XxxNR 3 *X +Au(CN) 2 xxx NR 3 *Au(CN) 2 + X
再藉由更強的陰離子樹脂或是用其它的化學反應 , 將吸附的金洗滌出 。通常最經濟實惠的替代反
應是用氰化鋅或是用硫代氰酸鹽將金洗出 , 如下 :
Elution of the adsorbed gold complex can be accomplished by displacement with a
more strongly adsorbed anion or by chemical reaction. Competitive displacement is
typically done with either zinc cyanide or thiocyanate:
XxxNR 3 *Au(CN) 2 + SCN + xxxNR 3 *SCN +Au(CN) 2
XxxNR 3 *Au(CN) 2 + Zn(CN) 4
2+
[xxxNR 3 *] 2 Zn(CN) 4 + 2 Au(CN)
不管以上是用何種方法洗滌出金錯化物 ,此強酸型陰離子樹脂最終都必須用硫酸或硫酸鐵將其轉
換回硫酸鹽型式 ,以利下一次的金吸附的反應機構模式。其回復的反應機構如下 :
In either case, the resin must then be converted back to the sulfate form prior to
return to adsorption service, typically with c sulfuric acid r or ferric sulfate.
however, the preferred method of elution is by chemical reaction with thiourea:
XxxNR 3 *Au(CN) 2 + SC(NH2) 2 + 2H2SO4 xxxNR 3 *HSO4 + 2 HCN
+ [ Au {SC(NH2)2}2] + HSO4-
) b) 用 弱堿型陰離子交換樹脂的應用 : : : :
另一種是用弱堿型的陰離子交換樹脂。由于此弱堿型的陰離子樹脂都是以自由基型式存在 , 所以
必須先用酸處理之后 , 再用來吸附金 。其反應機構如下 :
) b) K WEAK E BASE ANION:
An alternative approach to the above is the use of weak base anion exchange resins
which, because they are normally supplied in the "free base" form, need to be
treated with acid prior to contact with the leachate stream. A typical cycle is
conceptually as follows:
XxxNR 2 + HX xxxNR 2 H*X-.
XxxNR 2 H + X +Au(CN) 2 XxxNR 2 H + Au(CN) 2 +X -
XxxNR 2 H + Au(CN) 2 + NaOH XxxNR 2 + Na + Au(CN) 2 + H2O
因為弱堿型陰離子的高交換容量及可以得到較高的處理量 , 于小型的操作系統模式 , 通常都會用焚燒來
取代洗滌的方式來回收金 。
Because of the high capacity available with ion exchange resins and the high
loading that can therefore be obtained, in most small scale operations it is often an
option to consider incineration of the loaded resin rather than elution.
通常弱堿型陰離子交換樹脂最被常用于此貴金屬回收 。
Commonly the Weak base anion ion exchange resins are used for this application