砂泵適用說明：

（1）使用前，它應該是一個完整的真空，然后裝滿水的充分使用它，使其具有良好的泵浦功率。
（2）在安裝和使用，要注意改變方向，作為泵顯示箭頭，從而避免了部分被摧毀。
（3雖然使用），如橡膠管堵塞由沙子或砂礫，應予以拆除，并擺脫他們。不要操作機器，直接施加壓力，以避免膠管破裂。甚至不要攜帶和解除橡膠管，否則會動搖，因為壓力和傷害人民。
（4）在使用一段時間的，如果有油或水被發現泄漏，從機器的基礎，您可以調整螺絲同時使用按逆時針的方向作出封面am擦片與手橡膠碗在葉輪凸出的地方裝備（使用轉帶手輪，如果你遇到阻力，這將是合適的）。經過調整后，如果油或水韭菜不斷，橡膠碗，油封和軸套應該改變（如果有摩擦和不順利，應研磨，以避免軸承和泵基地被破壞）
（5雖然安裝橡膠碗），管道插座應面對的摩擦片，如果在相反的方向。在密封效果差。并應在泵水機前操作，否則，橡膠碗不容易破壞潤滑。
（6）在冬季結冰區，水應泵和石油倒應該加入到它的影響和應采取的良好照顧和避免生銹。

Matters needing attention
(1)    Before use, it should be a complete vacuum and then to fill it with water fully to use it to make it have excellent pumping power.
(2)    Before installing and use, to pay attention to changing the direction, as the arrow of pump shows, avoiding the parts being destroyed.
(3)    While using, if the rubber tube is blocked up by the sand or gravel, it should be dismantled and get rid of them. Don’t operate the machine and pressurize directly to avoid the rubber tube being fractured. Don’t even carry and lift the rubber tube, or else it will sway because of the pressure and hurt the people.
(4)    After using it for a while, if the oil or water is found to leak from the base of the machine, you can adjust the screw using both hands according to the anticlockwise direction to make the friction plate in the cover press together with the rubber bowl equipped in the bulgy place of the impeller (use the hand to turn belt wheel, if you meet resistance, it will be suitable). After adjusting, if the oil or water leeks continually, the rubber bowl, the oil seal and the axle sleeve should be changed (if there is friction and it doesn’t go smoothly, it should be grinded to avoid the bearing and the pump base being destroyed)
(5)    While installing the rubber bowl, the pipe socket should face the friction plate, if in the contrary direction. The effect of seal is bad. And there should be water in the pump before the machine is operated ,or else, the rubber bowl is easily destroyed without greasing.
(6)    In the icing area in the winter, water should be emptied from the pump and oil should be added into the bearing and it should be taken good care of and avoid being rusted.