空氣霧化噴嘴壓力傳送式噴霧裝置（外混式）

霧化噴嘴有點和特性：

通過外部混合裝置，無需改變液體流量，只需改變空氣壓力，即可對霧化進行控制。

對于扇形噴霧，尺寸A，B,和C是距離噴嘴相應距離處的噴霧角度；

Through the external mixing device, without changing the liquid flow, only need to change the air pressure, can to control the atomization.

For the fan-shaped spray, size A, B, and C corresponding distance is the distance the nozzle spray Angle;

The spray from the nozzle to the maximum dispersion point projection a total distance of D;

When using pressure conveying liquid system, liquid by pressure was taken to the nozzle;

Liquid and compressed air or other gas is mixed in the outside, to produce fully atomized spray;

空氣霧化噴嘴通過外部混合裝置改變氣體壓力而不改變液體流率來控制霧化，對于扇形噴霧，尺寸”A“流型寬度,如圖所示。噴嘴從噴嘴投射到很大彌散點的總距離為“D”。

霧化噴嘴可以隨時的調整氣壓和水壓，比例可隨時調整，1：15.

噴霧角度為扇形和實心。角度60°。

接口螺紋大小為3/4.

Air atomizing nozzle changing gas pressure by external mixing device without changing the liquid flow rate to control the atomization, the fan-shaped spray, dimension 'A' type flow width, as shown.Nozzle of projects from the nozzle to the maximum dispersion point total distance for the 'D'.

Atomizing nozzle can adjust the air pressure and water pressure, ratio can be adjusted at any time, 1:15.

The spray Angle for the fan and solid.Angle 60 °.

Interface thread size for three quarters.

工業霧化噴頭應用非常廣泛，針對不同類型的工況生產研發出各種不同型號的工業霧化噴頭，按照參與物體來分，工業霧化噴頭分為：工業單流體精細霧化噴頭和工業雙流體氣水霧化空氣霧化噴頭。不同點在于，單流體精細霧化噴頭是通過高壓來進行霧化的，雙流體空氣霧化噴頭是通過空氣和液體進行混合霧化的。按照材質的不同分為金屬工業霧化噴頭、不銹鋼工業霧化噴頭、黃銅工業霧化噴頭、塑膠工業霧化噴頭以及陶瓷工業霧化噴頭等;按照噴霧形狀可分為扇形工業霧化噴頭、廣角扇形工業霧化噴頭和圓形工業霧化噴頭。